Agricultural Plastic Shredder for Mulch Film, Drip Pipe & Shade Nets

It can be fed, but it should not be, and we would rather tell you that now than after your first blade bill. Sand and grit dull cutting blades quickly, so soiled film means frequent resharpening and falling throughput. Shake and beat the soil out at collection, and rinse heavily caked film before shredding. Recyclers also pay noticeably more for clean shred, so the washing effort comes back as price. If your stream is unavoidably dirty, say so in your enquiry and we will plan blade maintenance honestly into the recommendation.

Yes, used drip laterals are LDPE/LLDPE and pipe recyclers buy them readily once size-reduced. Cut the coils into machine-length pieces, feed them through a blade grinder like the RE series, and the screened regrind goes straight to granule makers. Flush pipes of water and mud first, and pull out metal fittings, joints and filters, metal entering the cutting chamber breaks blades. Emitters and drippers moulded into the pipe pass through with the regrind and are acceptable to most buyers. Confirm with yours.

Only after proper rinsing. The accepted practice is triple-rinsing the container (the rinse water goes into the spray tank, not the drain) and puncturing it so it cannot be refilled. Once triple-rinsed, containers are handled as plastic scrap and can be ground for recycling. Never shred containers with product residue, for the operator’s safety and because contaminated regrind has no legitimate buyer. Your local agriculture department or container-collection programme can confirm the rinsing protocol applicable in your state. We keep this general because rules differ.

Shade nets are the classic wrapping material, springy HDPE mesh that winds around a single fast rotor. That is why we point net-heavy streams to our dual shaft shredders: two slow, interlocked shafts pull the net down through the cutting zone instead of letting it ride around a blade. Feed nets in bundled armfuls rather than one long continuous sheet, and the machine works through them steadily. If nets dominate your stream, bring a bundle for a trial, tangling behaviour is exactly what a trial is for.

Most collection centres are seasonal: film arrives in a rush after harvest, pipe and net replacement is spread through the year. Size for your peak month, not the annual average. A centre aggregating 2–4 tonnes a month runs comfortably on a smaller RE-series grinder for a few hours a day. A district-level operation taking 1–2 tonnes a day needs a dual shaft shredder or a larger grinder. Our machine selection guide walks through the arithmetic, or tell us your collection estimates and we will size it for you.

Every machine is quoted to the job, because the price follows what the machine has to handle. What decides it is the model and its capacity, your material mix (film, pipe, nets or containers), the motor rating, MS or SS construction, options such as a blower that bags light film, and how you want to feed the machine and take the shred away. Our plastic shredder machine price guide walks through each of those. Send us your material and monthly volume and we will size the machine and quote it.

We provide installation and maintenance on site, with spares and blade sharpening guidance across India. The machines themselves are built for remote duty: all-metal construction with no plastic parts, simple blade sets an operator can learn to change, and routine care that amounts to lubrication and periodic blade sharpening. Keep a spare blade set on the shelf (we will tell you the sensible spares kit for your model when we quote) and a blade change becomes a planned job rather than a breakdown.